KTOG Bulletin Board
  P-32
  P32 measurement request

Post New Topic  Post A Reply
profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone! next newest topic | next oldest topic
Author Topic:   P32 measurement request
mikep
New Member

Posts: 3
From:IL
Registered: Jun 2001

posted June 06, 2001 12:35 PM     Click Here to See the Profile for mikep   Click Here to Email mikep     Edit/Delete Message     Reply w/Quote   Search for more posts by mikep      
I'm looking for a measurment for the mag floorplate. I'd like to know how wide the slot is for the bottom of the magazine, and the width of the portion that is for the flange at the bottom of the mag.
I'm hoping to use the NAA magazine grip extension floorplates for my FEG AP22, so I need to see if the dimensions are similar.

Thanks

------------------
"Tell me what you eat, and I'll tell you what you are."

IP Logged

GoldenLoki
Member

Posts: 36
From:Las Vegas
Registered: Jan 2001

posted June 06, 2001 08:07 PM     Click Here to See the Profile for GoldenLoki   Click Here to Email GoldenLoki     Edit/Delete Message     Reply w/Quote   Search for more posts by GoldenLoki   Visit GoldenLoki's Homepage!   

Mag body - squared at rear, rounded at front
length 1.064"
width 0.422"

flange - runs part way down each side
total width 0.515"
thickness .022"

floorplate tightly fits over these dimensions.

GL

------------------
http://www.goldenloki.com

IP Logged

mikep
New Member

Posts: 3
From:IL
Registered: Jun 2001

posted June 07, 2001 08:35 AM     Click Here to See the Profile for mikep   Click Here to Email mikep     Edit/Delete Message     Reply w/Quote   Search for more posts by mikep      
Thanks GL! That's the stuff I was looking for.

IP Logged

All times are ET (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | The Kel-Tec Owners Group

Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45c