posted October 06, 2000 10:50 PM                       

---

My P32 functioned perfectly until I sent my slide in for a hard chrome job. Evidently you don't get the same slide back ... who knows where it's been.
I fired several hundred silver tips without a problem ... before I sent my slide in to Kel-Tec for chrome. Now I have several complete failures to eject for every 50 rounds ... slide forward and still in the chamber.
I did clean with Eezox. Perhaps I overdid it. Any thoughts on what to look for would be most appreciated.

------------------

[This message has been edited by Patrick (edited October 06, 2000).]

posted October 07, 2000 02:08 AM                          

---

It's always best to send the whole gun. You may end up doing that anyway.
Mike

------------------

posted October 07, 2000 07:49 PM                          

---

your suspicions are correct. they do not chrome the parts you send them - they are replacements.
you may need to fluff & buff the chrome slide. i didn't need to on mine. i guess it may remove some of the chrome but the slide rails and hammer/slide interface should be lightly greased (see the "tec werks" lubrication guide) so there shouldn't be a rust concern if you take off some of the chrome doing this.

------------------

All times are ET (US)